weidnerl
Larry
Registered: January 2003
Posts: 150
|
This is a combination of the \"Warner bearing puller tool and a 5/8\"X4\" U-bolt. Just so happends that the holes in the warner tool are exactly 4\" apart and centered on the puller screw. I bought the \"U-bolt\" from NAPA and welded a 1/2\" bolt to the center of it. Then cut the bolt off at 1\" to make the nipple. The nipple goes into a 5/8\" hole in the frame above the torsion bar adjuster. The nipple on the end of the screw goes into a depression in the torsion bar adjuster.
|
