My initial idea was to use short intermediate belt assemblies to anchor to the floor and then the seat base. But that would make the whole seatbelt assembly actually route vertically rather than a more direct line to the floor. Using these brackets, the seatbelts can be mounted in a more direct route. When ordering these brackets keep in mind which way the bend is required. They are not identified as "Left" or "Right" but as "A" and "B" They actually are closer to how the factory would have achored the seatbelts. These photos are part of the install of a new aftermarket seatbelt solution By seatbeltplanet.com
No portion of this page, text, images or code, may be copied, reproduced,
published or distributed in any medium without the expressed written permission
of the copyright holder.