EAC44

Bottom side.    New 1/4 inch threaded hole ready for the carburetor stud.

When I changed the Intake Manifold to an Edelbrock aluminum performer, I also purchased a used Edelbrock finned air cleaner that I thought was kind of sexy!! The original air cleaner would not fit because the carburetor was now higher. I had to ensure the new air cleaner fit and found I needed to raise it to clear the accelerator pump and linkages. I also had to move the PVC Tube fitting to a better spot and improve the angle. While the air cleaner was in fact sexy, I did not like the intake noise that it transmitted. I later adapted the original air cleaner..