Fuel Injection

Snorkel is off a Jeep. I raised the snorkle to allow air to make the 90 degree turn into the TB using a piece of plastic pipe from the discard bin at a plumber\'s shop.  The sensor in the side of the riser pipe is the Intake Air Temperature (IAT).

Since the piece of pipe is not cut perfectly, I wrapped the top and bottom joints with Scotch 33 tape to prevent air leaks.

The aluminum piping goes to a cone shaped air filter (K&N lookalike) up front.  

The PO had cut out the hatch and fastened a piece of 5/8" plywood on top and then a piece of sheet aluminum on top of that.  Photo shows you really can\'t tell its higher.