The dryer, strainer, silver solder and other small parts I purchased from www.rparts.com. The strainer allows you to connect the existing capillary feed to the larger copper, I tried to keep the full length of the original capillary tube as it is sized for the evaporator. Before cutting any of the existing copper I cleaned the pipes well and planned the install so that the compressor wouldn\'t be opened to the environment for too long. I connected the vacuum pump and let it pull down to 29\" for the suggested time of 2hrs before adding the first charge of Duracool (r12a). The danfoss is factory charged with r134 and I didn\'t know about the fridges original charge, so after running the frige for a couple of hours I evacuted the system again and recharged with about 2.5 ounces, this showed a pressure of 15lbs with the compressor running at 2000 RPM with a current draw of 2.2 amps including the fan. Much better then Danfoss specs with a r134 charge.